NOTE: If you do not have Internet Access after connecting the modem/router (gateway) to the Linksys router, powercycle the router for 30 seconds and reboot your computer. Once your router detects that there is Internet access, it will give you an Internet Restored prompt. This information is provided by Verizon or can be found on your Verizon FiOS modem/router settings.Ĭlick the button located at the lower-right corner of the page.Ĭonnect the modem/router (gateway) to the Internet Port of the Linksys router. To do so, enter the information for your Internet IPv4 address, Subnet mask, Default gateway, and DNS entries. Specify and IPv4 address (Recommended) – Select this if you want to specify a Static IP address. Obtain an IPv4 address automatically – Select this if you want your Verizon FiOS modem/router to provide an IP address for your Linksys router.Ģ. There are two (2) IP Address configurations for your router:ġ. Set the IP Address configuration for your router. Set the Type of Internet Connection to Bridge Mode.
#FIOS ROUTER IP ADDRESS HOW TO#
In case you have forgotten your router password, click here to learn how to retrieve it.Ĭlick the Internet Settings tab and click Edit.
#FIOS ROUTER IP ADDRESS PASSWORD#
NOTE: If you have changed your router password, enter the new password instead. Enter the router's administrative password (default is “admin”) and click Sign In. You will be prompted to access the router. Launch your web browser and enter “192.168.1.1" or “myrouter.local” in the Address bar. Plug the power adapter to an electrical outlet and into the Linksys router. Do not connect anything to the Internet port for now. To set up the router to Bridge mode, follow the steps below.Ĭonnect an Ethernet cable from your computer to any of the numbered ports (1-4) at the back of the Linksys router. A router with Linksys Smart Wi-Fi web interface.An active Internet connection with your Verizon FiOS modem/router.IMPORTANT: Before configuring your router to Bridge mode, make sure you have the following: The router will not have the DHCP server functionality while the built-in firewall and NAT features will no longer take effect. Once the router is set to Bridge mode, some of its features will be disabled. You want to extend your network (additional LAN ports to your network).You want to use the router as an additional access point on an existing network.You have an existing modem/router from your existing Verizon FiOS modem/router.This configuration type is only applicable if: This article will help you configure a Linksys Smart Wi-Fi Router to Bridge mode for your existing network.
0 kommentar(er)
